Detailed explanation of construction steps and installation steps of wrought iron gate

Detailed explanation of construction steps of wrought iron gate
1. Construction preparation:
1. The manufactured wrought iron gate must have a factory certificate and a test report when entering the site, and check whether its specifications, models and dimensions meet the design requirements.
2. Put the window code in a safe place, pad it with wood, and cover it well. In order not to make mistakes, otherwise it will be difficult to cooperate with customers in the later stage.
3. Play the position line of the wrought iron gate, and determine the installation elevation according to the 50cm horizontal line.
4. The unpacking, inspection and transportation of the wrought iron gate are more important, because the wrought iron gate is not expected to be damaged during transportation.
5. Check the model and check the quality of the wrought iron according to the requirements of the drawings. If it is found that there are missing edges, channeling angles and uneven warping, deviations exceeding the standard, serious damage and scratches, and large appearance color difference,
It should be negotiated carefully, and it can only be installed after being repaired and qualified, and it is also necessary to check that the wrought iron gate is stuck with a protective film. If there is any defect, it should be repaired and then installed.
6. Prepare scaffolding during installation and take safety precautions.
2. Construction points:
Hole treatment of wrought iron gate: wrought iron installation adopts the installation method of reserving the hole and then plugging it. The horizontal position of the wrought iron hole should be based on the 50cm line of the wall, go up and down, go out of the window and the lower skin is elevated, and the elastic line should be straight. In order to ensure the upper and lower lines of the windows on each floor, the theodolite is used to hit the two sides straight on the wall. The gap between the plastic steel art frame and the wall should be 10-15mm on each side.
Connection between wrought iron gate and wall: the frame of wrought iron gate is connected with the wall with fixed iron parts. That is, use self-tapping screws to install the iron parts in the footing grooves on the outside of the window frame, and then send the iron gate door frame into the hole for positioning. Tighten the pipe expansion screw to fix the iron piece to the wall.
In a nutshell, it can be summed up in three points:
1. Material inspection
2. Quality inspection table
3. Concealed engineering
However, it is best for us to ask an engineer for detailed consultation before construction to see how to do it, so that we can adapt to local conditions and build beautifully.